TIPS FOR APPLYING VINYL
** Important**
Keep lettering covered with transfer paper until you are ready to apply it. Do not bend or fold. If you get kinks in it, it will be harder to apply.
For best results, pre-measure the selected location for your lettering. Using a level and/or a ruler is best. Mark position with your pencil. Make sure surface where lettering will be applied is clean, dry and smooth.
Rub over the lettering with a credit card or plastic spatula or something hard enough to make the transfer from the backing paper to the transfer paper.
Peel white backing paper away from the lettering and sticky transfer tape at an angle.
LIGHTLY position sticky ends of tape with lettering on the desired surface (wall, mirror, tile, board, etc). Gently adjust the position of the lettering if needed.
Gently rub over lettering with a credit card or plastic spatula to transfer to desired surface.
Slowly peel off the transfer tape at an angle, re-rub any lettering that sticks to the tape and re-apply pressure to lettering. You're done!